中文字幕日本一区久久|欧美亚洲尤物久久精品|香蕉国产精品偷在线播放|国产成人亚洲片在线观看|国产精品免费线观看你懂的|香蕉久久夜色精品国产下载|国产成人精品免高潮在线观看|精品中文一区二区三区在线视频

Vibration plate manufacturers briefly introduce the purpose of the vibration plate:

1. Automatically sort the workpieces and automatically feed them to the assembly machine, instead of tedious manual manual sequencing, especially the arrangement of small and ultra-small workpieces that are not easy to operate manually.

2. Sort out unqualified workpieces

3.Accelerate production speed and improve efficiency

4. The use of a vibration plate can reduce the number of labor, improve labor efficiency, and reduce operating errors.

5. Vibration discs for products with particularly high hygiene requirements are less likely to cause pollution than artificial production, and can also improve the overall image of the factory.

Equipped with relevant automated machinery and equipment, the vibrating plate can partially or completely replace labor, realizing fast, accurate and smooth automatic loading and automatic assembly of the production process

Vibration plate adjustment steps:

1. Make sure that the vibration body is located on the surface of the disk and is locked.

2.Turn the controller button to the middle position or to the number 130 ~ 180;

3. Turn on the power and check whether the conveying speed of the vibration plate reaches the requirements;

4. If it does not meet the requirements, do not disconnect the power, loosen any one of the fixing screws of the lock shrapnel, and check the vibration speed change;

5. If you loosen the elastic screw of the elastic sheet and the vibration speed becomes faster, it means that the elastic sheet is too thick, and the number of elastic sheets or the thickness of the elastic sheet should be reduced moderately, then go to step 4 and debug again;

6. If you loosen the fixing screws of the shrapnel and the vibration speed becomes slower, it means that the shrapnel is too thin. After increasing the number or thickness of shrapnel moderately, go to step 4 and debug again;

7. If the adjustment of step 4, the vibration speed does not change much, it means that the shrapnel adjustment has been completed;

8. The electromagnets should be aligned, the gap should be 1-1.5 mm, and the gap should be parallel.